Weaving garment production process should pay attention to the problem

1. It is very important to test the shrinkage rate of the fabric before cutting and adjust the pattern according to the shrinkage rate.

2, the main process of knitwear is copying, depending on the density, width, line color and quality of the copying edge as required.

3, the problem of the side of the gesture. For example: two trouser legs, the length of the general factory has a length of time, to reduce the gap between the long short legs, you must ask the driver's gesture. Just one of the trouser legs was rushed to the raft, so the mechanic was asked to lick the fabric slightly. When changing the other trousers, it was to the trousers. At this time, the fabric could not be smashed, but the fabric was pushed.

4, the problem of ironing of accessories, knitwear sometimes has to be equipped with some ribbons, elastics and other accessories, but the shrinkage of these accessories is difficult to match with the fabric, this time must first require the factory to pre-shrink the fabric (pre-reduced Shrinking machine pre-shrinking), all kinds of accessories with shrinkage rate can be burned before doing it.

5, after the ironing is very important, the phenomenon of long sleeves and other phenomena presented during the processing, the deformation of the various parts can be adjusted by ironing, it can be said that most of the knitwear is hot.

6, the other is the general local to pay attention to the local.